The shower and the hand wand piping was nothing, but getting over to the body sprays was tricky. I was worried about the pressure drop along the way, and still have concerns that it will not be sufficient to have the shower and the sprays on at the same time. I thought I would finish it last night, but I had one joint in the pressure balancing configuration for the body sprays that did not go together right. It was the last joint I had to do, of course, and everything was too tight to make it work. I had to rip it apart this morning to get it all to fit correctly. There are fifty solder joints in all that had to be made after I had the valve rough in completed. None of them leak. Not too bad, actually, for an electrical engineer!
By the way, none of those scorch marks are mine. They were there from old plumbing. Now that I think about it, that one on the left for the shower wand might have been me. I can’t remember for sure. Also, I ended the soldering with just over two inches of solder wire left.
My only concern now is that I may have misjudged the thickness of the wall when it is all done. I remember the shower wand fitting really tightly in the hall bathroom, and I didn’t want to come up short. I guess we will see in another freakin’ year when the whole thing is done…
Plumber's